Post-mortem room equipment

Autopsy Table Selection and Room Planning

Compare autopsy tables by intended procedure, work-surface arrangement, sink and drainage needs, ventilation concept, transfer method and the utilities available in the room.

Engineering notice: dimensions, material grade, load, sink and grinder configuration, lifting functions, airflow, duct connection, water, drainage and electrical requirements vary by model. Coordinate the current technical drawing with qualified local specialists.

YSENMED stainless steel autopsy table for mortuary and pathology room planning
The table is one component of the room system; building services and operating procedures must be coordinated separately.

Compare Table Configurations by Function

Use these pathways to identify the required functions. Inclusion of a function in one model does not mean it is standard on every table.

YSENMED downdraft autopsy table with sink, faucet and ventilated base

Downdraft table

Coordinate the airflow concept, exhaust connection, make-up air and commissioning method with the room ventilation designer.

View downdraft autopsy table

YSENMED autopsy table with sink for water and drainage planning

Table with sink

Confirm hot and cold water, pressure, inlet points, drain size and location, waste treatment and cleaning procedures.

View autopsy table with sink

YSENMED autopsy table with stretcher lifter for body transfer planning

Table with stretcher lifter

Check the transfer approach, height range, rated load, platform compatibility, operating method and maintenance access.

View table with stretcher lifter

Room and Building-Service Checks

  • Define the intended procedures, work zones and required cleanable room finishes.
  • Coordinate exhaust airflow, duct route, fan responsibility, discharge location, make-up air and room pressure strategy.
  • Confirm water temperature and pressure, inlet locations, drain capacity and waste-treatment responsibility.
  • Provide voltage, frequency, connected-load requirements, isolation and protection for the selected configuration.
  • Plan floor loading, anchoring, delivery route, doorway clearance and service access.
  • Agree on testing, balancing and commissioning responsibilities before shipment.

Information to Send with an RFQ

  • Room drawing and destination country.
  • Intended procedure and selected table functions.
  • Required work-surface, sink and accessory arrangement.
  • Ventilation design basis and available duct route.
  • Water, drainage and electrical connection information.
  • Body-transfer equipment and approach direction.
  • Documentation, installation, testing, training and warranty expectations.

Autopsy Table Procurement Questions

Does a downdraft table provide a complete room ventilation system?

No. The table’s connection and capture concept must be integrated with ductwork, fans, make-up air and the room pressure strategy by qualified project specialists.

Are water, drainage and electrical connections standardized?

No. Confirm every connection size, location, demand and local standard against the selected model’s current technical drawing and the facility design.

What should be agreed before installation?

Approve the equipment drawing, utility responsibilities, delivery route, anchoring or mobility, testing and commissioning method, included accessories and the installation scope.

Coordinate the Table with the Complete Mortuary Room

Send the room drawing, procedure and utility information together for a configuration review.